I broke my tail boom on a hard landing. The complete break was about 1/2 way back. Need suggestion on how to repair.
Been there, done that.
Clean the area around the crack as good as you can. Scouring powder, Scotchbrite pad and elbow grease to remove all mold release agent, accumulated grime, etc. Thoroughly rinse with water. The gluing area should look uniformly hazy. If you are still worried about clean, wipe the whole area down with isopropyl alcohol, 91% Once cleaned NEVER touch the area again, handle only with gloves on. Finger prints will weaken the joint. Without a good cleaning of the area, nothing else will really matter that much. Be anal about a good cleaning.
Align the whole tail assembly as good as you can by eye and then soak the fracture area with thin CA to hold it in position when you glass.
Do not use latex gloves for handling epoxy resin, use only vinyl or nitrile rubber gloves. You can get vinyl or nitrile gloves at good drug stores or paint stores. I get mine at either Costco or Walmart. Bad things in the epoxy resin easily move through latex rubber.
Take several short sections of glass tape and one longer one for wrapping. The short sections should extend minimum 1-1.5 inches either side of the crack. Mix up a slow curing epoxy, soak all glass tape and then squeeze out or blot out as much epoxy as you can. Squeezing between a couple of pieces of polyethylene works well. Align the several short pieces of tape parallel to the fuse evenly spaced out around the perimeter. Wrap the fracture area with the longer piece of epoxy soaked tape pulling it as snug as you can. Wrap that with waxed paper and then then whole thing with an Ace bandage. Looks very medical. Give it a generous amount of time to cure up. After a day or two of cure, unwrap, admire the nice clean repair. Warm up repair with a hair drier to totally complete cure, making sure to put no load on the assembly whilst the fuse is warm from this heating (you will distort the epoxy on the first heat if you apply any pressure.)
Rebalance and check to make sure that your elevator and rudder settings are copasetic and you are ready to rock and roll! This last point is really important. Don't ask me how I know. ;-)
Cheers,
Bill
--
In theory, there is no difference between theory and practice, but in practice there is.
Bill Johns Pullman, WA USA
RCSE-List facilities provided by Model Airplane News. Send "subscribe" and "unsubscribe" requests to [EMAIL PROTECTED] Please note that subscribe and unsubscribe messages must be sent in text only format with MIME turned off.

