Stan,
> I broke my tail boom on a hard landing. The complete break was about 1/2
way
> back. Need suggestion on how to repair. I was thinking of putting in a
> 1/64th ply tube epoxying that in mating the two pieces of the boom, then
> using glass on the exterior.
>
> If the ply tube is a good idea, how long would it need to be?
I've repaired or assisted in the repair of several molded fuselages that had
broken booms. What has evolved as my best method follows. It also leaves
you with a fuselage that when painted looks like new and is at least as
strong as the original.
1. Using CA, glue everything back as close to the original position.
Maintain the alignment of the fuselage while doing this. Don't worry about
pretty or neat, just get everything back to as close to the original as
possible. What you are trying to do is reestablish the alignment and
handling strength of the fuselage.
2. Psychologically, this is hard to do the first time. Cut an oval hole,
longer front to back than circumferentially, that opens up about 1/4 of the
damaged area. There should be no damaged material outside the area of the
hole either in front of or behind the hole. Directly opposite the first
hole cut a second hole with similar properties.
3. Sand a bevel on the edge of the hole at least 1/4" wide and rough up the
interior of the fuselage as far as you can reach with a small grinding wheel
in a Dremel tool.
4. From .007" precured, unidirectional carbon laminate cut an oval that
overlaps the second hole by about 1/2" on each side front to back and 1/8"
on each side circumferentially - with the unidirectional fibers running
front to back. Place this piece of carbon inside the fuselage, hold in
place and tack with CA. Once this CA has set, flood the patch with CA,
inside and out.
5. Using 2.5 or 3 ounce glass cloth (or whatever matches the original
fuselage material) cut a patch to cover the outside of the hole. Spray the
patch lightly with 3M 77 and press into the recess. Flood the patch with
CA, let cure, sand off any bumps in the depressed area and block sand to
remove excess material around the patch. Later you will add additional
patches to bring the fuselage up to the original thickness.
6. Repeat the hole cutting and patching two more times on either side of the
first patch. You now have 3/4 of the repair completed.
7. The last hole can be the trickiest, but can be completed in two different
ways. One, if you have access to the inside of the tail boom from the front
you can place the last carbon patch, place a balloon down the tail boom and
blow it up to hold the patch while you glue it. Or, by gluing a balsa stick
to the patch you can insert the patch, pull out on the stick and glue the
carbon patch in place.
8. Fill in the remaining depressions in the fuselage by layering glass and
gluing in place with CA.
A bit of filler, some paint and the fuselage is back to the original
appearance and stronger than when new. The stronger than new comment comes
from experience with two crashes with my Ellipse 1T. The fuselage had been
repaired after the first crash using this method. The second crash broke
the fuselage behind the original repair.
This method is definitely more time consuming than the plywood cylinder, but
I believe it's far stronger and leaves the fuselage looking much better than
most other repairs.
Jim Porter
Neckargemund-Dilsberg
Germany
"The airplane stays up because it doesn't have the time to fall."
Orville Wright
RCSE-List facilities provided by Model Airplane News. Send "subscribe" and
"unsubscribe" requests to [EMAIL PROTECTED] Please note that subscribe and
unsubscribe messages must be sent in text only format with MIME turned off.