Hi again,
I followed the manual and tried to set up some options via ip (iproute2).
First any can related command failed until I found out that the box used the
busybox's ip derivate. So I downloaded the git repository as mentioned here
in another thread:
git://git.kernel.org/pub/scm/network/iproute2/iproute2.git
I cross compiled it but besides the statistics none of the additional
commands are supported.
~ # ip link set can0 type can restart-ms 2000
RTNETLINK answers: Operation not supported
~ # ip -details -statistics link show can0
2: can0: <NOARP,UP,LOWER_UP> mtu 16 qdisc pfifo_fast state UNKNOWN qlen 64
link/can
RX: bytes packets errors dropped overrun mcast
0 0 0 0 0 0
TX: bytes packets errors dropped carrier collsns
1 1 0 0 0 0
Are there any special things to be taken care of when cross compiling
iproute2 to make it support anything needed with can?
Best regards
Ulrich
-----
Best regards
Ulrich
--
View this message in context:
http://old.nabble.com/On-Linux-two-applications-use-the-same-bus--tp30728796p30748053.html
Sent from the Socket-CAN Users mailing list archive at Nabble.com.
_______________________________________________
Socketcan-users mailing list
[email protected]
https://lists.berlios.de/mailman/listinfo/socketcan-users
