Angus Beath wrote: > Hi Mark, > > it should but it doesn't seem to? Maybe I've stuffed up the install. I > followed the instructions on the OpenBSD site - do I then need to do > anything further? A follow up guide or something would be great. > > Thanks for your reply.
it's pretty hard to screw up the install, however, your message lacks detail... What did you do? What did you expect to happen? What did you see actually happen? You may be looking for this: http://www.openbsd.org/faq/ most notably: http://www.openbsd.org/faq/faq11.html Nick. > Angus > > On Tue, May 25, 2010 at 10:31 PM, Mark Kettenis > <[email protected]>wrote: > >> > Date: Tue, 25 May 2010 16:52:41 +1000 >> > From: Angus Beath <[email protected]> >> > >> > Hi guys, >> > >> > recently I've been given a Blade 1500 with a XVR-600. I've played with >> Linux >> > a lot over the years but OpenBSD confounds me! I have managed to install >> > OpenBSD on this device, but I'm at a bit of a loss of where to go from >> here. >> > I know that xenocera supports the XVR-600 using the wildcatfb and ifb >> > drivers but how to get them into a place where X can see them and >> implement >> > them is confusing me. Any help will be very greatly appreciated. >> >> If your machine has just that XVR-600, it should just work.
