Hi Mark, I'll give that a lash a bit later today and see if it works.
Thanks for the tip. Angus On Wed, May 26, 2010 at 7:34 PM, Mark Kettenis <[email protected]>wrote: > > Date: Wed, 26 May 2010 11:56:00 +1000 > > From: Angus Beath <[email protected]> > > > > Nick, > > > > I followed (to the letter) the Sparc installation FAQ. After reboot, I > ran X > > at the # prompt and it immediately dropped me back to the # prompt. I > have > > run through the Sparc64 X notes and changed the aperture to 1. > > > > The X log is as follows: > > > > (--) Using wscons driver > > > > X.Org X Server 1.6.5 > > Release Date: 2009-10-11 > > X Protocol Version 11, Revision 0 > > Build Operating System: OpenBSD 4.7 sparc64 > > Current Operating System: OpenBSD blade1500.INtelephony.local 4.7 > > GENERIC#258 sparc64 > > Build Date: 15 March 2010 06:22:14PM > > > > Before reporting problems, check http://wiki.x.org > > to make sure that you have the latest version. > > Markers: (--) probed, (**) from config file, (==) default setting, > > (++) from command line, (!!) notice, (II) informational, > > (WW) warning, (EE) error, (NI) not implemented, (??) unknown. > > (==) Log file: "/var/log/Xorg.0.log", Time: Wed May 26 11:47:38 2010 > > (II) Loader magic: 0x1b20 > > (II) Module ABI versions: > > X.Org ANSI C Emulation: 0.4 > > X.Org Video Driver: 5.0 > > X.Org XInput driver : 4.0 > > X.Org Server Extension : 2.0 > > (II) Loader running on openbsd > > (--) PCI: (0:0:6:0) 10b9:7101:0000:0000 Acer Labs M7101 Power rev 0 > > (--) PCI: (1:0:3:0) 3d3d:07a2:3d3d:1047 3D Labs Wildcat 5110 rev 1, Mem @ > > 0x04000000/67108864, 0x00100000/131072, 0x02000000/ > > 33554432, BIOS @ 0x????????/65536 > > Primary device is not PCI > > (==) Using default built-in configuration (12 lines) > > (==) --- Start of built-in configuration --- > > Section "Device" > > Identifier "Builtin Default wsfb Device 0" > > Driver "wsfb" > > EndSection > > Section "Screen" > > Identifier "Builtin Default wsfb Screen 0" > > Device "Builtin Default wsfb Device 0" > > EndSection > > Section "ServerLayout" > > Identifier "Builtin Default Layout" > > Screen "Builtin Default wsfb Screen 0" > > EndSection > > (==) --- End of built-in configuration --- > > Grr, things got broken in 4.7. For now you'll need a minimal > xorg.conf with something like the following contents: > > Section "Device" > Identifier "Device0" > Driver "wildcatfb" > EndSection
