All,
Had an interesting scenario today and just couldn't figure out how to do it in
OneClick (the 'Graph was so much easier).
Here's the scenario.
We had a port disabled (moving from Frame Relay to MPLS) which generated the
necessary "BAD LINK DETECTED". After removing the old link, the new link was
"drawn" in OneClick from a specific tunnel interface on one Router DIRECTLY to
the other router (other interface was unknown at the time of modeling).
When I learned the particular port on the "other router", I couldn't figure out
how to move the OPR to the correct port - so I did it the "old fashioned way",
launched SG, opened the DEVTOP view of the router, put it into edit mode, and
literally dragged the OPR to the correct port.
Is there a similar method in OneClick or do I have to start the connection on
one port, then end the connection on a different port?
Please advise.
Fred
_________________________________________________________________
Want to read Hotmail messages in Outlook? The Wordsmiths show you how.
http://windowslive.com/connect/post/wedowindowslive.spaces.live.com-Blog-cns!20EE04FBC541789!167.entry?ocid=TXT_TAGLM_WL_hotmail_092008
---
To unsubscribe from spectrum, send email to [EMAIL PROTECTED] with the body:
unsubscribe spectrum [EMAIL PROTECTED]
