Hi You can click on the port in the interface table and chose start connection. On the other model do the same but chose connect with..
Regards Christian Schneider Enterprise Service Specialist 4-tune GmbH Sägereistrasse 29 CH-8152 Glattbrugg Tel +41 71 930 07 00 Fax +41 71 930 07 01 Mob +41 79 418 45 42 Mail [EMAIL PROTECTED] On 21.10.2008, at 22:56, F J Rutcho <[EMAIL PROTECTED]> wrote: > All, > > Had an interesting scenario today and just couldn't figure out how > to do it in OneClick (the 'Graph was so much easier). > > Here's the scenario. > > We had a port disabled (moving from Frame Relay to MPLS) which > generated the necessary "BAD LINK DETECTED". After removing the old > link, the new link was "drawn" in OneClick from a specific tunnel > interface on one Router DIRECTLY to the other router (other > interface was unknown at the time of modeling). > > When I learned the particular port on the "other router", I couldn't > figure out how to move the OPR to the correct port - so I did it the > "old fashioned way", launched SG, opened the DEVTOP view of the > router, put it into edit mode, and literally dragged the OPR to the > correct port. > > Is there a similar method in OneClick or do I have to start the > connection on one port, then end the connection on a different port? > > Please advise. > > Fred > > Want to read Hotmail messages in Outlook? The Wordsmiths show you > how. Learn Now > --To unsubscribe from spectrum, send email to [EMAIL PROTECTED] with > the body: unsubscribe spectrum [EMAIL PROTECTED] --- To unsubscribe from spectrum, send email to [EMAIL PROTECTED] with the body: unsubscribe spectrum [EMAIL PROTECTED]
