As long as you specify in the setscript and clearscript file to pass the event message itself (done via echo "EventMessage: The following $SEV Alarm has OCCURRED - $EVENTMSG"), you will get the information that you are talking about. I have Disk Monitoring setup on all of our servers and below is what is passed to the email (keep in mind though, that we are not using E-Health - just Spectrum):
EventMessage: The following MAJOR Alarm has OCCURRED - Tue 25 Nov, 2008 - 10:08:36 The disk 'd:\ label:new volume serial number ec4d938c' also known as 'D:\ Label:New Volume Serial Number ec4d938c' has exceeded the maximum utilization threshold of 85 Percent. Utilization at the time of this event was 86 Percent. This disk is being monitored by model smcmimsdbtest.select.corp.sem. This is an MAJOR event. Host_Device (name - smcmimsdbtest.select.corp.sem). - (event [0x00c40032]) ________________________________ From: Schlundt, Gerard [mailto:[EMAIL PROTECTED] Sent: Tuesday, November 25, 2008 9:49 AM To: spectrum Subject: RE: [spectrum] SANM and Alarm Details I thought I already did... I want the details from the alarm - the cause file is essentially what is sent, but the specific technical information is not. For example, a time-over-threshold coming from eHealth saying that 'drive c' on a server is getting full. As SANM work snow, the only information you would get is the cause file that might say 'a disk is getting full' - leaving out the critical specifics - drive letter and current utilization. -----Original Message----- From: Christian Schneider [mailto:[EMAIL PROTECTED] Sent: Tuesday, November 25, 2008 8:33 AM To: Schlundt, Gerard Cc: spectrum Subject: Re: [spectrum] SANM and Alarm Details Please specify what information you would like to see in the Mail Regards, Christian Schneider Enterprise Service Specialist 4-tune GmbH Sägereistrasse 29 CH-8152 Glattbrugg Tel +41 71 930 07 00 Fax +41 71 930 07 01 Mob +41 79 418 45 42 Mail [EMAIL PROTECTED] Am 25.11.2008 um 14:19 schrieb "Schlundt, Gerard" <[EMAIL PROTECTED] >: > Here's a question for you. I am working in Spectrum 9, although in > this > particular area the behavior seems to be the same as it was in > Spectrum > 8. > > > > When an alarm is generated (any alarm) SANM can send a notification to > an email gateway. This works fine except for the fact that all that > is > passed is the basics - what landscape, model name, model type, and the > text from the pcause file. > > > > The problem is that the specific information from the alarm detail is > not included in the alarm. This is what truly needs to be passed - > but > I can't find a way to get it into SANM for email notification. Is > this > possible - or have I run into a limitation of the product? > > > --- > To unsubscribe from spectrum, send email to [EMAIL PROTECTED] with > the body: unsubscribe spectrum [EMAIL PROTECTED] * --To unsubscribe from spectrum, send email to [EMAIL PROTECTED]<mailto:[EMAIL PROTECTED]> with the body: unsubscribe spectrum [EMAIL PROTECTED] Note: The information contained in this message may be privileged and confidential and protected from disclosure. If the reader of this message is not the intended recipient, or an employee or agent responsible for delivering this message to the intended recipient, you are hereby notified that any dissemination, distribution or copying of this communication is strictly prohibited. If you have received this communication in error, please notify us immediately by replying to the message and deleting it from your computer. Thank you. select.corp.sem --- To unsubscribe from spectrum, send email to [EMAIL PROTECTED] with the body: unsubscribe spectrum [EMAIL PROTECTED]
