Hello Rob, Spectrum does all of this,
Use SANM and SANM policy to forward. You can then configure where you want to send the alarm in the Notifier scripts, in the Notifier directory. You can then use the mail or the trap creator in spectrum to send a specific trap. Good luck. Dildar Kahlon Senior ESM Architect IT Outsourcing Division Ciber Tel: 732-623-5442 Fax: 732-225-2973 [email protected] <mailto:[email protected]> From: Rob [mailto:[email protected]] Sent: Tuesday, October 09, 2012 6:17 PM To: spectrum Cc: spectrum Subject: Re: [spectrum] SNMP trap filtering application Part of the eHealth distro.... On 10/9/2012 5:11 PM, nikhil mehra wrote: use Trap Exploder. On Tue, Oct 9, 2012 at 2:59 PM, Bohra, Saurabh <[email protected]> wrote: All, I am looking for an application which can do trap filtering for us. Any recommendations will be helpful. I am looking for following functionalities. 1. Should be able to process SNMP v1 and v2c traps. 2. Process up to 100 traps/second. 3. Discard a trap based on Enterprise OID, generic and specific trap type combination. 4. Discard a trap based on the value of variable binding. 5. For all other trap, preserving the source IP address and the entire trap variable bindings, should be able to forward it to at least 5 destinations. 6. The application should be able to support HA/DR. * --To unsubscribe from spectrum, send email to [email protected] with the body: unsubscribe spectrum [email protected] --- To unsubscribe from spectrum, send email to [email protected] with the body: unsubscribe spectrum [email protected]
