I have a large-size grease fitting (with a pipe thread) that "almost" fits into the hole. I remove the plug, screw in the grease fitting (not too tight), and grease it up. Then I put the plug back.
I guess you could also use a grease gun with a cone-shaped rubber tip. Doug At 08:18 PM 10/31/2004 -0600, you wrote: >Hey Doug, > When you take the rack off and try to clean every thing up, so you can put >your new gaiters and tie rod ends on, what's the procedure for greaseing the >works without a grease zerk on the pinion box? > >Larry *** http://www.team.net/the-local *** Your messages not reaching the list? Check out http://www.team.net/posting.html *** unsubscribe/change address requests to [EMAIL PROTECTED] or try *** http://www.team.net/cgi-bin/majorcool *** http://www.team.net/mailman/listinfo *** Archives at http://www.team.net/archive *** Edit your replies!