Dave,

If the other two can't help. Contact me off Forum. I've done a lot of mill projects in New England.

Todd


At 01:15 PM 4/7/2008, you wrote:
Good afternoon to all,

If someone on the list with a hydraulic calc program could do me the favor of calculating the friction loss over the following run it would help tremendously. I have a 1920's circa mill complex that has endured some deferred maintenance and now tenant storage / commodity problems. The owners have come to the table and are now working with us (AHJ) to repair / resolve our concerns. I'm just trying to estimate water delivery to the remote point so we can do some comparison with available flows on the property.

I have calculated out the elevation losses from the city supply pressure and would like to know what kind of pipe friction loss I can expect to the remote area. The system is now dry (was wet in 1920 but converted to dry around 1980) - a whole different story - and is using standard weight threaded pipe and fittings (pipe schedule no doubt). I have 70 psi at base of riser and after elevation loss Im down to 46 psi. Now factor in the following pipe run:

45 feet of 6 inch + 35 feet of 4 inch + 15 feet of 2 1/2" + 10 feet of 1 1/2" + 10 feet of 1" to end of branch line.

I dont have any programs to help me with that and would appreciate it someone could run that through for me so I can have the end head pressure. Thanks very much.

  Dave P.
  An AHJ in NJ
_______________________________________________
Sprinklerforum mailing list
[email protected]
http://lists.firesprinkler.org/mailman/listinfo/sprinklerforum

To Unsubscribe, send an email to:[EMAIL PROTECTED]
(Put the word unsubscribe in the subject field)

Todd G. Williams, PE
Fire Protection Design/Consulting
Stonington, Connecticut
www.fpdc.com
860.535.2080 _______________________________________________
Sprinklerforum mailing list
[email protected]
http://lists.firesprinkler.org/mailman/listinfo/sprinklerforum

To Unsubscribe, send an email to:[EMAIL PROTECTED]
(Put the word unsubscribe in the subject field)

Reply via email to