You have to do what you have to do if you break you break it easy out next move if that doesn’t work cap the branch line run a new one with dry sidewalls
Sent from my iPhone > On Sep 28, 2017, at 2:30 PM, Mike Stossel <[email protected]> wrote: > > What about using a pipe? Take a pipe with an I.D. capable of going over an > 18" wrench and measure the distance down to the hanging hole at the bottom of > the wrench. Drill a hole at that point and through bolt it so you can't lose > the wrench. Slide the pipe out to the dry pendent and hook it to loosen. > Once you loosen it a little bit you should be able to take it out the rest of > the way with a head wrench. > > Mike Stossel SET > > 36 Barren Road > East Stroudsburg, PA 18302 > Office: 973-670-2627 > [email protected] > > -----Original Message----- > From: Sprinklerforum [mailto:[email protected]] > On Behalf Of proud-texan > Sent: Thursday, September 28, 2017 2:23 PM > To: [email protected] > Subject: Removing Dry Sprinklers > > We have a freezer that we need to change some Dry Sprinklers. > Unfortunately, there is less than 12" clear space above it so no way to get a > man above it to wrench the head loose. When we try to remove it with a head > wrench, it refuses to budge. If we break the head, we will be up the > proverbial creek. Does anyone have any ideas short of disassembling the > freezer to change heads? > > _______________________________________________ > Sprinklerforum mailing list > [email protected] > http://lists.firesprinkler.org/listinfo.cgi/sprinklerforum-firesprinkler.org > _______________________________________________ > Sprinklerforum mailing list > [email protected] > http://lists.firesprinkler.org/listinfo.cgi/sprinklerforum-firesprinkler.org _______________________________________________ Sprinklerforum mailing list [email protected] http://lists.firesprinkler.org/listinfo.cgi/sprinklerforum-firesprinkler.org
