If the wire feed speed was slowed to a crawl and small diameter wire used,
MIG would work. It wouldn't be as pretty, however, as a TIG Joint.
----- Original Message -----
From: <[EMAIL PROTECTED]>
To: "Multiple recipients of sslivesteam" <[EMAIL PROTECTED]>
Sent: Sunday, September 10, 2000 5:18 AM
Subject: Re: Propane Tanks
> In a message dated 9/10/2000 2:57:32 AM Pacific Daylight Time,
> [EMAIL PROTECTED] writes:
>
> > I doubt can you weld mig on a workpiece 3 inches
> > long?
> I can gas weld it though, with very small tight bead.
> Bob
>
>