Further to the Lathe question.

I do not know the Taig so I cant comment. The Unimat was an Austrian
product. The company went bankrupt some years ago. some models have
been produced by a British manufacturer in the meantime. The general
opinion is that they are not as good as the original Austrian models.
Maybe made in the third world??

The model offered by Micromark is also offered worldwide under various
names and colors. It would not be my choice. I prefer "V" belts or
gears to Electronics

If you want the ultimate machine in my opinion and this is generally
confirmed anywhere in the world, Myford is the only lathe that comes
into question. There are more accessories from various sources for the
Myford than for any lathe I know of. The machine has been built
virtually unchanged for over 60 years. Which other machine has a
gearwheel directly behind the head bearing which is literally a built
in dividing head with a simple plunger which fits in the teeth. Etc
Etc.. I am convinced that with a Myford and L.H. Spereys books "A man
and his lathe" or The amateur's lathe" and you can do almost anything
after a little practise.  The older models with white metal bearings
are , if the bearings are good??  much better than the roller bearing
lathes.

Thats my two penneth on lathes.

Incidental we have just built 7 off 2cyl. wobblers we used square
brass for the cylinders which is a lot of metal to warm up but they
perform very good indeed. These are the first wobblers we have built
and I must admit that they are fun and look very busy when running. We
were surprised how economical they are. We have had one run on level
track of 1hr 20 minutes without replenishing gas or water.

Bert in Austria.


-------------------------
Bert &  Edmunda
[EMAIL PROTECTED]

_______________________________________________
SSLiveSteam mailing list
Send messages: [email protected]
Cancel subscription: http://postfix.45mm.com/mailman/listinfo/sslivesteam
Rules: http://www.45mm.com/sslivesteam_guide.html

Reply via email to