At 09:43 AM 1/3/07 -0500, you wrote:
>For my second project I'd like to attempt to build a clack valve to
>attach to the backhead fitting of my C-16. First I will need to learn
>how to use my lathe to cut threads (M5x0.5), that might take some time.
David,
Clack/check valves are perhaps the most basic and often made fitting
and have been described in a virtually every locomotive construction
article ever published and most of them follow the same pattern; they use a
captive stainless steel, bronze, or nitrile (hard rubber) ball. Rarely
does anyone bother with anything else until you reach 7+ga and even then
balls are the majority first choice.
The important things in the valve are the size of the water passages
(ie, the ball seat diameter) vs. the diameter of the ball, and the lift of
the ball. There are optimum proportions for these dimensions. In large
scale valves, such as 7+ga, where the weight of the ball can be a factor,
return springs might be used. But in small scale the ball weight is
generally not a factor and because the lift of the ball is (or should be)
limited the ball is never allowed to get very far from its closed position
and the flow of water acts to carry the ball back onto the seat.
One of the most troublesome things in all of live steam is getting a
hard (ie, metal) ball valve to seat and seal against water or steam
pressure. Using nitrile rubber reduces this almost to nil but still the
ball seat must be properly made and the ball seated in. There is
recommended process for this too and one part of it is to ream rather than
drill the hole through the ball seat because a drill makes a lopsided hole.
Lots to learn isn't there?
My guess is you will need an (90°) angle valve the body of which
will be made in two pieces (body and stem) and silver-soldered together.
Soft solder might do the job but generally silver-solder is normally used
for boiler fittings. My suggestion would be while you're at it make an
extra body or two, in case you have to make another try.
My preference for water line connections is a nut & cone connection,
which is relatively easy to make, but you will need a bottoming tap when it
comes to threading the nut. I can't guess or recommend a size because I
don't know what the overall size of the valve body will be, and although
thread cutting is a good thing to learn you might start with this project
collecting taps and dies, you will eventually need them.
Ssomewhere I have the information I've quoted and I'll have to dig
it out, and I'm also scanner-free at the moment so I can't post it but I'll
see what I can dig up that is postable.
Regards,
Harry Wade
Nashville Tennessee
_______________________________________________
SSLiveSteam mailing list
Send messages: [email protected]
Cancel subscription: http://postfix.45mm.com/mailman/listinfo/sslivesteam
Rules: http://www.45mm.com/sslivesteam_guide.html