Only a real old time super-macho done-it-all machinist would give this 
kind of advice!   No kid raised on numerical control machine tools knows 
about this stuff!  Believe it!

==========

Arthur S. Cohen (by way of Dave Cole) wrote:

>Hi Dave,
>If you can get the correct change gears to generate the thread pitch 
>you need and the internal or external thread goes right up to a 
>shoulder and you want to "do it your self" do the following:  First 
>make sure that you are opening the correct pitch by machining 
>anything cylindrical.  Just a scratch will do for checking.  Then 
>chuck the item you want to cut threads on and do it by hand.  You 
>don't have to use the lathe's motor to rotate the chuck for 
>threading.  Rotate the chuck by hand.  This way you have very precise 
>control to get up against the shoulder.  Since you are opening a very 
>small .5 mm pitch on a copper alloy you don't have to worry about 
>feeding the cutting tool in at a 59º or 60º angle.  You can just 
>plunge in at 90º and in 3 or 4 light cuts you will have what you are 
>trying to do the first time. 
>Arthur--Mexico City
>_______________________________________________
>SSLiveSteam mailing list
>Send messages: [email protected]
>Cancel subscription: http://postfix.45mm.com/mailman/listinfo/sslivesteam
>Rules: http://www.45mm.com/sslivesteam_guide.html
>
>
>  
>

_______________________________________________
SSLiveSteam mailing list
Send messages: [email protected]
Cancel subscription: http://postfix.45mm.com/mailman/listinfo/sslivesteam
Rules: http://www.45mm.com/sslivesteam_guide.html

Reply via email to