To all,
Sorry I've been off the list for a while with computer problems and
have changed my provider and now have a new E-Mail address.
At Sinsheim steam meeting in Germany 11th 12th and 13th Jan. I had
the honour of firing up the pre production of Accucraft Germany's new
Saxon KIII. (see SitG) The engine is articulated between 2ns and
third axle. the cab is split and the roof is in 2 parts the rear
hinginf off to the left and the front part hinging forward! The Klose
valve gear with split con rods looks great. The engine had arrived
in Germany two days before and Lorenz Schug had manged to get a servo
into the small cab. As we were out on the track and did not have
measuring glasses etc I did not get to measure the amount of water
the boiler took. I think it is enough to say that engine's first run
lasted well over half an hour. but I had not waited until the boiler
or gas tank were empty. The engine is gauge adjustable 32/45mm. The
paint job is great as is the rivet detail and lettering. In short
this may well be the first non American engine I would like to see on
my roster The unusual valve gear looks not only very busy when
running but is an eye catcher. I assume the engine will have better
low speed control as she gets run in. As I took her out of the box
there was no trace of oil in the smoke box or fire tube.
I and my 3 pals Have been invited to Sinsheim again to run our
engines at the model exhibition in March 13th - 17th where I will
have a second chance of running the KIII and making more detail notes.
Regards
Bert in Sunny Austria.
--
mailto:[EMAIL PROTECTED]
_______________________________________________
SSLiveSteam mailing list
Send messages: [email protected]
Cancel subscription: http://postfix.45mm.com/mailman/listinfo/sslivesteam
Rules: http://www.45mm.com/sslivesteam_guide.html