Hello Geoff, Thursday, February 21, 2008, 1:27:49 AM, you wrote:
>>Dear Bert in sunny Austria, > Thanks for the report on the Saxon KIII, 'tis an interesting loco- > sounds as if you have ordered one!. > Anything else at Sinsheim that you think would interest us?- Lots of > things I bet, too many to list! > It's been cold and wet up here in the redwoods so I haven't steamed > but Diamondhead was wonderful as usual, many coal fired locos and the > new alky fired Aster GN s2. A couple of very interesting diesel > electrics were running, one commercial by Jerry Hyde. one scratch > built RC by Bob Pope which I had the pleasure of ""steaming"" It was > amazing! Unfortunately I missed Jerry's diesel, - probably in the > bar! > Thanks again, you are keeping sslivesteam alive. > Geoff. >>To all, >> >>Sorry I've been off the list for a while with computer problems and >>have changed my provider and now have a new E-Mail address. >> >>At Sinsheim steam meeting in Germany 11th 12th and 13th Jan. I had >>the honour of firing up the pre production of Accucraft Germany's new >>Saxon KIII. (see SitG) The engine is articulated between 2ns and >>third axle. the cab is split and the roof is in 2 parts the rear >>hinginf off to the left and the front part hinging forward! The Klose >>valve gear with split con rods looks great. The engine had arrived >>in Germany two days before and Lorenz Schug had manged to get a servo >>into the small cab. As we were out on the track and did not have >>measuring glasses etc I did not get to measure the amount of water >>the boiler took. I think it is enough to say that engine's first run >>lasted well over half an hour. but I had not waited until the boiler >>or gas tank were empty. The engine is gauge adjustable 32/45mm. The >>paint job is great as is the rivet detail and lettering. In short >>this may well be the first non American engine I would like to see on >>my roster The unusual valve gear looks not only very busy when >>running but is an eye catcher. I assume the engine will have better >>low speed control as she gets run in. As I took her out of the box >>there was no trace of oil in the smoke box or fire tube. >> >>I and my 3 pals Have been invited to Sinsheim again to run our >>engines at the model exhibition in March 13th - 17th where I will >>have a second chance of running the KIII and making more detail notes. >> >> >>Regards >>Bert in Sunny Austria. >>-- >> >> mailto:[EMAIL PROTECTED] >> >>_______________________________________________ >>SSLiveSteam mailing list >>Send messages: [email protected] >>Cancel subscription: http://postfix.45mm.com/mailman/listinfo/sslivesteam >>Rules: http://www.45mm.com/sslivesteam_guide.html > _______________________________________________ > SSLiveSteam mailing list > Send messages: [email protected] > Cancel subscription: > http://postfix.45mm.com/mailman/listinfo/sslivesteam > Rules: http://www.45mm.com/sslivesteam_guide.html Hi Geoff, I'm pleased to see that at least one person is alive and well. Thanks for your answer. Sinsheim was, as usual Great for the 5" and 71/4" gauge fans. I get the feeling that gauge one is going downhill somewhat. On the other hand people like Manfred Regner are selling woblers like hot buns. Accucraft is not doing so good in Europe with US models, probably because the importers have to pay more for their models than customers do when they buy at US discounters. This brings with it problems. No dealer is going to do any guarantee work on engines imported privatly. Frankly I understand the dealers here. The loosers are the customers and eventually Accucraft because many modelers are loosing faith. I know a guy who has 2 electric engines with troubles, he bought at a US discounter. The discounter says send them to the manufacturer for repair. Post one way is about $500.00 each. So he is not happy. My Climax "Chicken shed" has had her body removed and is now cut down to a "cabriole" sort of loco. The up side is you can see the engine working. No I have not ordered a KIII. At least not yet. She is a great eye catcher. I hear that Hr Schug has had a series of cars built to go with the loco. I cant wait to see them. Have fun Bert -- Best regards, Bert mailto:[EMAIL PROTECTED] _______________________________________________ SSLiveSteam mailing list Send messages: [email protected] Cancel subscription: http://postfix.45mm.com/mailman/listinfo/sslivesteam Rules: http://www.45mm.com/sslivesteam_guide.html
