Hi
The ifup eth0 returns: operation failed
I have the rtl8139.o on the disk.
modprobe rtl8139 returns: init_module: Device or resource busy
It suggests that it might be something with I/O or IRQ
In kdecontrol i can se that a unknown ethernetcontroller is detected with
I/O 0xEC00 IRQ10
If it is something with failed detecting my network card during boot, can i
then control/alter I/0 and IRQ somewhere in a config file?
best regards Lars
----- Original Message -----
From: "mike polniak" <[EMAIL PROTECTED]>
To: "StormIX Userlist" <[EMAIL PROTECTED]>
Sent: Wednesday, February 21, 2001 10:29 PM
Subject: Re: [SLU] 2.06 not supporting netcard with rtl8139?
> Lars Myrthu Rasmussen wrote:
> > Hi
> >
> > I have a PC with a D-Link 538 network card. The chip is a Realtek 8139.
> > The network does not work after installing storm 2.06. Ifconfig tells me
> > that an IP address has not been assigned (DHCP). Also networking start
> > fails. There is a rtl8139.o listed in modules.conf, for eth0.
> > If i try to assign an IP address manually by: ifconfig eth0 inet
> > 192.168.0.10 up, the output is: eth0 unknown interface.
>
> Following up my post: Also check /etc/modutils/storm
> It should have: alias eth0 rtl8139.o Then if you run> update-modules
> it will put the alias line in /etc/modules.conf for you, so when eth0
> is detected it will load rtl8139.o automatically.
> --
>
>
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
~~~
>
> _______________________________________________
> Stormlinux-users-list mailing list
> [EMAIL PROTECTED]
> http://www.stormix.com/community/lists/listinfo/stormlinux-users-list
>
_______________________________________________
Stormlinux-users-list mailing list
[EMAIL PROTECTED]
http://www.stormix.com/community/lists/listinfo/stormlinux-users-list
