Ooops. Yes. Thanks for the tip. On Jan 18, 2017 12:13 AM, "Jakob Erdmann" <[email protected]> wrote:
> was there an active subscription for this vehicle? > > 2017-01-18 2:17 GMT+01:00 Mani Amoozadeh <[email protected]>: > >> Hi, >> >> >> >> Through TraCI, I added a vehicle into SUMO. >> >> Then at some point of the simulation, I remove it. >> >> SUMO-GUI removes the vehicle but shows the following error message: >> >> >> >> Error: Answered with error to command 0xa4: Vehicle 'stopped_veh' is not >> known >> >> >> >> After the error, the simulation is on-going and everything seems to be ok. >> Here what I did: >> >> >> >> 1. Adding the vehicle through TraCI with these parameters: >> >> >> >> name: "stopped_veh" >> >> type: "DEFAULT_VEHTYPE" >> >> route: route1 >> >> depart: 5*1000 >> >> lanePos: 3200 >> >> lane: 1 >> >> >> >> 2. make the vehicle stop by changing its speed to 0 and set the lane >> change >> mode to 0. >> >> 3. change the color to red >> >> 4. change vClass to "custome1" >> >> 5. set vehicle length to 5 >> >> 6. remove the vehicle with reason = 2 >> >> >> >> - Mani >> >> ------------------------------------------------------------ >> ------------------ >> Check out the vibrant tech community on one of the world's most >> engaging tech sites, SlashDot.org! http://sdm.link/slashdot >> _______________________________________________ >> sumo-user mailing list >> [email protected] >> https://lists.sourceforge.net/lists/listinfo/sumo-user >> > > ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, SlashDot.org! http://sdm.link/slashdot _______________________________________________ sumo-user mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/sumo-user
