Andreas Höschler wrote:
Ray 1g. Obviously the DTU cannot determione the possible
resolutions by asking the screen, since the log in screen is
displayed at 640x480.
Is this monitor so ancient that it doesn't report its supported
timings through DDC? Is it possible that you're using a bad cable,
or that the cable isn't properly connected? Was the monitor
powered on when you powered on the Sun Ray?
I have attached an older montr capable of doing 1280x1024 to a Sun
Yes, but I use a RGB-cable (VGA-cable got lost somehow, an dthis
cable does not support DDC).
Definately go get yourself a new (fully wired) VGA cable. This is such
an ANNOYING problem that can be so easily fixed by spending a few dollars.
I once purchased 100 * (uber-cheap) VGA cables not realizing they didn't
have the DDC pin connected, oh the pain and anguish I suffered!!!
_______________________________________________
SunRay-Users mailing list
[email protected]
http://www.filibeto.org/mailman/listinfo/sunray-users
