Hi, I'm getting ready to install a 120 GB EIDE drive in my S900 w/ G4 processor and was wondering if anyone had any particular thoughts about which bay to use. I have a USB card in my bottom slot and am planning to install a new ATA controller card in the slot right above that. I�m also planning to install OS 9.1 on the new drive and make that the boot drive, retaining the original 2 GB drive that came w/ the computer as a secondary drive. Do I make the old drive the last link in the internal SCSI chain of the S900 and exactly how do I do that? Also, as per instructions that came w/ the new drive I have to check the jumper settings on the old drive to see if it�s configured for Master or Cable Select and then set the jumper on the new drive accordingly. Anything I should be aware of regarding these jumper settings? Any other tips or advice anyone cares to pass along regarding the installation I have described will be appreciated. And thanks for replies to past queries. You people know your stuff and your responses have been most helpful.
Elliot -- SuperMacs is sponsored by <http://lowendmac.com/> and... Small Dog Electronics http://www.smalldog.com | Refurbished Drives | Service & Replacement Parts [EMAIL PROTECTED] | & CDRWs on Sale! | Support Low End Mac <http://lowendmac.com/lists/support.html> SuperMacs list info: <http://lowendmac.com/supermacs/list.shtml> --> AOL users, remove "mailto:"; Send list messages to: <mailto:[EMAIL PROTECTED]> To unsubscribe, email: <mailto:[EMAIL PROTECTED]> For digest mode, email: <mailto:[EMAIL PROTECTED]> Subscription questions: <mailto:[EMAIL PROTECTED]> Archive: <http://www.mail-archive.com/supermacs%40mail.maclaunch.com/> --------------------------------------------------------------- >The Think Different Store http://www.ThinkDifferentStore.com ---------------------------------------------------------------
