No TCP port 25 appears in the logs. I have a lot of UDP etc but no TCP/IP from my IP
I have three internal sub nets and have turned on advanced nat so I can add each sub net. I have also added routing rules for the internal gateway but apart from that it is a vanilla setup > -----Original Message----- > From: Scott Ullrich [mailto:[EMAIL PROTECTED] > Sent: 02 May 2006 16:53 > To: support@pfsense.com > Subject: Re: [pfSense Support] Port Forwarding > > > On 5/2/06, Robert Mortimer <[EMAIL PROTECTED]> wrote: > > I have a set of 6 public IP addresses > > I set up pfSense with an internal IP in the 10.0.0.x range and use an > > external IP > > All is good except I can not port forward to my mailserver or webserver. > > > > I have been to the Firewall: NAT: Port Forward tab and set up the port > > forward (including the addition of the firewall rule) > > > > In NAT I see the following > > > > IF Proto Ext. port range NAT IP Int. port range > > Description > > WAN TCP 80 (HTTP) 10.0.0.10 25 (SMTP) > > Mailserver > > ext.: 80.176.108.60) > > > > In Rules I see the following rule > > > > Proto Source Port Destination Port Gateway Description > > TCP * * 10.0.0.10 25 (SMTP) * NAT > Mail server > > > > When I plug my PC into the ADSL hub and give it one of my static IP > > addresses I can ping my router's external IP but I can not > telnet to port > > 25. > > > > The same setup works with my old Linux smoothwall box (i.e. I > can telnet to > > port 25) > > > > I also want to add a rule to drop and log all outbound SMTP > that does not > > originate from a machine in my mailservers group. I set up the group > > mailservers to include the requisite machines. I add the > following rule to > > LAN > > > > TCP ! MailServers 25 (SMTP) * * > * Block in not mailserver > > > > I reload the rules but still I can telnet out to my ISP's mailserver > > > > > > C:\Documents and Settings\rob>telnet post.demon.co.uk 25 > > 220 anchor-post-33.mail.demon.net ESMTP Tue, 02 May 2006 15:33:21 +0000 > > quit > > 221 anchor-post-33.mail.demon.net closing connection > > Connection to host lost. > > C:\Documents and Settings\rob> > > > > I am running Beta 3 > > Look in the filter logs and see what is blocking it. Click on the red > X to the left and it will tell you which rule triggered the block. > You can then use this information to see why its not working. > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [EMAIL PROTECTED] > For additional commands, e-mail: [EMAIL PROTECTED] > > > --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
