Anders,
Thank you for your firsthand account. I was looking at this unit, but
concerned about the realtek nics... I've had problems with those in
the past, but if it works for you, then I'm interested. Are you able
to use each of the 6 lan ports on this unit as a different interface/
subnet in PFsense? If so, PFsense makes this a heavy duty little box.
(too bad about the current USD exchange rate though).
Thanks Again,
Jeremy
On Nov 4, 2007, at 6:57 PM, Anders Dahl wrote:
Hi Mahalo
I've been running 1.0.1-embedded on a FX5620, available at linitx.com
http://linitx.com/viewproduct.php?prodid=10909.
It's been running now for 6 months, without any problems at all.
Kind regards
Anders Dahl
-----Oprindelig meddelelse-----
Fra: Jeremy Bennett [mailto:[EMAIL PROTECTED]
Sendt: 5. november 2007 05:00
Til: support@pfsense.com
Emne: [pfSense Support] New Build
I've been running PFsense successfully on a handbuilt PC for about a
year now, and am stoked that it works so well. I'd like to move onto
the next step and do an embedded setup. Can anyone recommend the best
board/vendor for this approach?
I'd like to have at minimum 3 lan ports, but also optimize for ease
of setup/maintenance.
Any recommendations from those that have already done this?
Mahalo,
Jeremy
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
