For some reason I locked my self out remotely out of the desktop with a
tftp server install. Port25 is connected to the router so I tagged it on
all vlan's and left the ports to the computer untagged under its
designated vlan setup. In the pfsense I created a vlan1 to match the
default on the switch and changed LAN from rl0 to vlan1 on rl0. Still
not passing dhcp or if set static can;t ping. When I'm back in the
office on Tues I'll do a firmware update on the switch and post back.
Thank you for you help. I starting to figure it out and unfortunately I
learn better by doing then reading.. Should I only trunk the connecting
ports if I add another switch
vlan on the pfsense interface, the traffic will default to it. Not
sure why that is.... The LAN interface should say "VLAN 1 on bge0
(VLAN1)" ...if this is so then your other VLAN's should follow
suite. For the switchport connected to pfsense, it should be tagged
(Trunked in Cisco Terms) on all VLANs. After those steps are
completed, you should be able to plug in a host on the switch with an
untagged VLAN interface and be able to pass traffic. There's probably
other ways to do this but I do know this method works 100% of the time.
What NIC's are you running?
--
Curtis LaMasters
http://www.curtis-lamasters.com
http://www.builtnetworks.com
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
