Thank you for the answer, I will try it out tomorrow. You mean that I have to enable the parent interface and leave all the fields empty ?
2008/11/25 RB <[EMAIL PROTECTED]> > On Tue, Nov 25, 2008 at 14:13, Cozma Szabi <[EMAIL PROTECTED]> wrote: > > I cannot find what I have to set on the parent card, or what I must to > check > > on VLAN interfaces. > > Unlike Cisco equipment, you don't have to set anything on the parent > interface, VLAN tagging is turned on by default. If you read the > link, you will be shown the steps necessary to set up 802.1q VLAN > interfaces. Here's a preview, it's dead simple: > > - Interfaces->(assign)->VLAN > - "+" -> fill out parent interface & tag number > - wash, rinse, repeat > > Once configured, they appear as ethernet interfaces, there is no > difference between them and the parent physical interfaces. You can > click on the Interfaces->(assign) page and it will show you that > particular interfaces are VLAN children of others, but that's about > the only differentiation you will see. > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [EMAIL PROTECTED] > For additional commands, e-mail: [EMAIL PROTECTED] > > Commercial support available - https://portal.pfsense.org > >