Hi Everyone,
I have been trying to figure out how to setup multiple wan networks on a
single bridge.
For instance:
111.111.111.111/25 -> em0/bridge0/opt1 -> internal servers
222.222.222.222/25 -> em0/bridge0/opt1 -> internal servers
I see a way to add a virtual IP in the Firewall section, but not to add
a VIP to the em0 Interface. I have em0 bridged with em1 and my bridge
is setup with allowing certain ports through to internal servers, each
server has an external IP so I have to use bridged mode, not NATing.
Any help would be much appreciated.
Thanks
Joe
--
This message has been scanned for viruses by Colocube's AV Scanner
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
Commercial support available - https://portal.pfsense.org
