On Fri, Jul 24, 2009 at 7:59 PM, Joseph L. Casale<jcas...@activenetwerx.com> wrote:
> No more vlan config inside pfSense, I have 3 physical interfaces, lan, wan, > opt1. > wan is segmented off to a dsl which works, nat with lan is functioning. Opt1 > is > on a port that untags into vlan3. I *know* this works as I just hooked up a > rhel > host with an IP in the vlan 3 subnet that *does not* have vlan config and it > can > see hosts in vlan3. Opt1 has an ip in the vlan3 subnet but still no > connectivity. > > My rules are lan->* and opt1->*. > > I have no gateway configured on Opt1, no bridging, clients in vlan3 have their > gateway set to opt1's ip which is set to 192.168.2.1/32. > > What else can I check? > > Thanks for everything! > jlc > Have you configured rules for natting from opt1 out to the internet? I know that for lan are configured automagically, but I'm not sure what happens with opt1. Also, does another host in vlan3 see the pfsense box (either by ping or checking if it resolves the MAC address of pfsense's ip, using "arp -a"). Regards. --------------------------------------------------------------------- To unsubscribe, e-mail: support-unsubscr...@pfsense.com For additional commands, e-mail: support-h...@pfsense.com Commercial support available - https://portal.pfsense.org
