sorry forgot to mention that i see this in the logs:
openvpn[5850]: /etc/rc.filter_configure tun1 1500 1542 192.168.1.1
192.168.1.2 init
openvpn[5850]: /sbin/ifconfig tun1 192.168.1.1 192.168.1.2 mtu 1500
netmask 255.255.255.255 up
openvpn[5850]: TUN/TAP device /dev/tun1 opened
so i assume the tun interface gets created, but it's not shown in the
interface list.
Joseph L. Casale wrote:
How can i create an OPT interface assigned to a tun interface?
I knew that reply I wrote was a bit sloppy:)
Make the OpenVPN config first specifying the Custom Opt as tun0.
Save it.
Then go back to your Interface Assignments and the Network port
selection will now have a tun0 interface.
jlc
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
Commercial support available - https://portal.pfsense.org
--
** <http://www.aironaut.ch/> *Andreas Fuchs*
Consultant/System Engineer Allmend 31
3504 Niederhünigen office: +41 31 508 18 16
mobile: +41 78 740 93 80
[email protected] <mailto:[email protected]>
www.aironaut.ch <http://www.aironaut.ch/>
