Here's my setup:
WAN - dhcp via cable modem
LAN - to switch with gigabit wired connections 192.168.1.x
OPT1 - to linksys WAP 192.168.2.x
Any devices on subnet 2 cannot access subnet 1, and vice versa, even
though I have rules which allow it. The problem is that I have a print
server on subnet 1 that devices on 2 need to access. Pings will not go
through from either side, though from pfsense I can ping subnet 2 from
the OPT interface, and can ping subnet 1 from the LAN interface. Devices
of the same subnet see each other with no problems.
Here are my rules
LAN:
allow any from OPT subnet to LAN subnet
allow any from LAN subnet to OPT subnet <--I tried adding this rule
after I discovered my problem and it did not help.
OPT:
allow any from LAN subnet to OPT subnet
allow any from OPT subnet to LAN subnet <--I tried adding this rule
after I discovered my problem and it did not help.
Any suggestions? I'm sure it's something simple, but my networking
knowledge is novice level.
Thanks!
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
Commercial support available - https://portal.pfsense.org
