On Sun, Jun 13, 2010 at 8:52 PM, Josh <anothernum...@atlanticbb.net> wrote: > Here's my setup: > WAN - dhcp via cable modem > LAN - to switch with gigabit wired connections 192.168.1.x > OPT1 - to linksys WAP 192.168.2.x > > Any devices on subnet 2 cannot access subnet 1, and vice versa, even though > I have rules which allow it. The problem is that I have a print server on > subnet 1 that devices on 2 need to access. Pings will not go through from > either side, though from pfsense I can ping subnet 2 from the OPT interface, > and can ping subnet 1 from the LAN interface. Devices of the same subnet see > each other with no problems. > > Here are my rules > > LAN: > allow any from OPT subnet to LAN subnet
This is wrong. > allow any from LAN subnet to OPT subnet <--I tried adding this rule after I This is the only rule you need on LAN. > OPT: > allow any from LAN subnet to OPT subnet this is wrong. > allow any from OPT subnet to LAN subnet <--I tried adding this rule after I > discovered my problem and it did not help. > That is the only rule you need on OPT. I suspect your WAP is blocking it, or a host firewall. Use the Diag > Packet capture screen to confirm traffic is entering and leaving the appropriate interfaces, and as long as it is, you know the firewall is ok and need to troubleshoot at the hosts and AP. --------------------------------------------------------------------- To unsubscribe, e-mail: support-unsubscr...@pfsense.com For additional commands, e-mail: support-h...@pfsense.com Commercial support available - https://portal.pfsense.org
