"[EMAIL PROTECTED]" ha scritto:
> At 02:15 PM 1/10/00 +0100, you wrote:
> >I don't know... Anyway If you send me your controller I'm sure to configure it
> >correctly.
>
> heh. starting to seem like an idea!
> Oh well, may as well get you a plane
Plane?!? Where are you from?
> ticket here, you could fix BOTH my
> modem probs then.
>
> >I'm supposing your controller card have com ports.
> >There is a possibility to detect how to configure your controller. Have you a
> >digital multimeter?
>
> nope
>
> >If you have not one, are you able to build a primitive digital tester?
>
> also nope
You need a LED a 330 ohm resistor and a 7400 chip and of course a bit of wire.
>
> >(Of course there are some jumpers on your controller, are not they?)
> >Have your own ICQ number? How is your clock related to GMT? i.e: GMT+1, GMT+2
> >GMT-3?
>
> icq= 4898262 (id yerself plz)
Since you have not a multimeter and or a logic probe your ICQ is not so usefull,
sorry.
> GMT-0600
America?
I live in Italy.
....
Ah! Can you send me a post card? I like post card, I someone can send me a post
card I'll reply with an italian one. Please who find this topic interesting e-mail
me. [EMAIL PROTECTED]
> I have noticed that two other i/o cards have the same jumper setup so maybe
> they all work the same and it is possible to apply instructions from another
> I will try a search on "I/O card jumpers" next
IRQ line 3 and 4 are located on B25 B24 ISA BUS connector, that is:
+---------------------------------+
|solder side controller card. |
| |
| old xt bus +-+ Exten. |
| dcba| | AT |
+---------------------+ +---------+
a=B31 line
b=B30 line
etc..
Follow B24 and B25 wire will tell you what is the IRQ jumper selector. I hope I/O
jumper setting is near this one.
OR
Use the following algoritm:
0) WRITE DOWN JUMPER CONFIG.
1) REMOVE ALL CONTROLLER'S JUMPERS.
STEP WHAT FOLLOW NOW CAN BE APPLIED ALSO ON A POWERED COMPUTER, IF YOU ARE NOT SURE
ABOUT WHAT YOU ARE DOING TURN OFF IT. SHORTS CAN DAMAGE CONTROLLER CARD AND
COMPUTER PARTS.
2) INSERT A JUMPER
3) CONTROLL IF YOUR MODEM IS DETECTED CORRECTLY
4) IF YES GO TO STEP 2
5) OTHERWISE LET THIS JUMPER POSITION EMPTY THEN RESTART FROM STEP 2.
HAVE FUN PIPPI!!!
To unsubscribe from SURVPC send a message to [EMAIL PROTECTED] with
unsubscribe SURVPC in the body of the message.
Also, trim this footer from any quoted replies.
