Bernie wrote:
>
> 1. Create bare.i bootdisk (net.i doesn't find NIC)

This is a bad sign.  If the net.i kernel doesn't see your
card, then there may be a hardware problem.  Perhaps an IRQ
or address conflict?  Does your network card have jumpers?
Or perhaps it has a DOS installation routine?

> 1. My card is believed to be an "acenic" card - using this
> later fails since eth0 isn't there.

I assume you tried ifconfig?

> (Red Hat didn't know this - it installed it and upon booting
> crashed the system forcing me to remove the card (same one I'm
> using now)

Sure sounds that a hardware problem to me.
BTW it is not unusual for an ne2000 card to lock up a system on
the second boot (after a soft reset).  Apparently the soft reset
isn't enough to clear the ne card and it trips up the subsequent
Linux boot.  A hard reset (after Linux's soft reset) avoids this
problem.

> modprobe ne io=0x360

Are you sure your network card is ne2000?
Are you sure your network card is set to 0x360?

> /lib/modules/2.2.13/net/ne.o: init_module: Device or resource busy

Could be an address conflict.  0x320 and 0x300 are more commonly
used for network cards.

> BTW: This computer doesn't have any "Plug�n�Pray" BIOS functions -
> that they were one there was the reason my NE2000 PCI card didn't
> work well in my main machine at first (except in DOS).

I've found that the latest distributions of Linux don't install as
easily on old hardware.  If you have 486-era hardware, you may have
fewer problems installing an older distribution, like Slackware 3.x.

Don't give up.  There are still plenty of things to try.
For example, does that computer/networkcard work in DOS (this can
be done from a DOS boot floppy, so there is no need to touch your
Linux installation).  If you can get a DOS packetdriver working,
then the same parameters should work in Linux.

Cheers,
Steven

To unsubscribe from SURVPC send a message to [EMAIL PROTECTED] with 
unsubscribe SURVPC in the body of the message.
Also, trim this footer from any quoted replies.
More info can be found at;
http://www.softcon.com/archives/SURVPC.html

Reply via email to