On 7/18/05, [EMAIL PROTECTED] <[EMAIL PROTECTED]> wrote:
> Dear friends,
> 
> saya lagi coba bikin bridge dengan konfigurasi sbb:
> 
>                                        br0 (192.168.100.11)
>                              +--------------------------------+               
>             192.168.100.254
>                              !                                !               
>            +----------------+
>      LAN ----//----- eth0 ---+                                +- eth1 
> ------------------+   Router       +---> Internet
>             via              !                                !            
> Cross         +----------------+
>            switch            +--------------------------------+            
> Cable
> 
> 
> untuk simulasi saya gunakan konfigurasi berikut:
> 
>                                        br0 (192.168.100.11)
>                              +--------------------------------+               
>             192.168.100.254
>                              !                                !               
>            +----------------+
>      notebook_a ---- eth0 ---+                                +- eth1 
> ------------------+   notebook_b
>             cross            !                                !            
> Cross         +----------------+
>             cable            +--------------------------------+            
> Cable
> 
> 
> 
> command yg saya run:
> 
> # ifconfig eth0 0.0.0.0
> # ifconfig eth1 0.0.0.0
> # brctl addbr br0
> # brctl addif br0 eth0
> # brctl addif br0 eth0
> # ifconfig br0 up
> # ifconfig br0 192.168.100.11 netmask 255.255.255.0 up
> 
> output ifconfig command:
> 
> br0       Link encap:Ethernet  HWaddr 00:04:75:BC:BE:90
>           inet addr:192.9.18.11  Bcast:192.9.18.255  Mask:255.255.255.0
>           inet6 addr: fe80::204:75ff:febc:be90/64 Scope:Link
>           UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
>           RX packets:49 errors:0 dropped:0 overruns:0 frame:0
>           TX packets:28 errors:0 dropped:0 overruns:0 carrier:0
>           collisions:0 txqueuelen:0
>           RX bytes:3914 (3.8 Kb)  TX bytes:1864 (1.8 Kb)
> 
> eth0      Link encap:Ethernet  HWaddr 00:0A:5E:04:62:84
>           inet6 addr: fe80::20a:5eff:fe04:6284/64 Scope:Link
>           UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
>           RX packets:49 errors:0 dropped:0 overruns:0 frame:0
>           TX packets:34 errors:0 dropped:0 overruns:0 carrier:0
>           collisions:0 txqueuelen:1000
>           RX bytes:12510 (12.2 Kb)  TX bytes:2496 (2.4 Kb)
>           Interrupt:10 Base address:0xe400
> 
> eth1      Link encap:Ethernet  HWaddr 00:04:75:BC:BE:90
>           inet6 addr: fe80::204:75ff:febc:be90/64 Scope:Link
>           UP BROADCAST MULTICAST  MTU:1500  Metric:1
>           RX packets:0 errors:0 dropped:0 overruns:0 frame:0
>           TX packets:112 errors:0 dropped:0 overruns:0 carrier:0
>           collisions:0 txqueuelen:1000
>           RX bytes:0 (0.0 b)  TX bytes:9574 (9.3 Kb)
>           Interrupt:11 Base address:0xe800
> 
> eth2      Link encap:Ethernet  HWaddr 00:04:75:DA:1C:64
>           inet addr:192.168.18.253  Bcast:192.168.18.255  Mask:255.255.255.0
>           inet6 addr: fe80::204:75ff:feda:1c64/64 Scope:Link
>           UP BROADCAST MULTICAST  MTU:1500  Metric:1
>           RX packets:0 errors:0 dropped:0 overruns:0 frame:0
>           TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
>           collisions:0 txqueuelen:1000
>           RX bytes:0 (0.0 b)  TX bytes:0 (0.0 b)
>           Interrupt:11 Base address:0xec00
> 
> lo        Link encap:Local Loopback
>           inet addr:127.0.0.1  Mask:255.0.0.0
>           inet6 addr: ::1/128 Scope:Host
>           UP LOOPBACK RUNNING  MTU:16436  Metric:1
>           RX packets:47 errors:0 dropped:0 overruns:0 frame:0
>           TX packets:47 errors:0 dropped:0 overruns:0 carrier:0
>           collisions:0 txqueuelen:0
>           RX bytes:4416 (4.3 Kb)  TX bytes:4416 (4.3 Kb)
> 
> output route command:
> 
> Kernel IP routing table
> Destination         Gateway         Genmask            Flags Metric
> Ref    Use Iface
> localnet              *                     255.255.255.0   U
> 0        0        0     br0
> 192.168.18.0     *                    255.255.255.0    U       0
> 0        0    eth2
> loopback           *                     255.0.0.0           U
> 0       0        0      lo
> default               192.9.18.254   0.0.0.0             UG       0
>   0        0     br0
> 
> Hasilnya :
> 1. notebook_a bisa reply ping dari bridge, begitu juga sebaliknya.
> 2. notebook_b tidak bisa reply ping dari bridge, begitu juga sebaliknya.
> 3. notebook_a tidak bisa reply ping dari notebook_b, begitu juga sebaliknya.
> 
> pertanyaan:
> bagaimana agar hasil no. 2 dan no. 3 tidak terjadi? sehingga dari kedua
> notebook bisa saling reply jika dilakukan ping.
> 
> thanks in advanced
> sigid
> 
> 
> --
> Unsubscribe: kirim email kosong ke [EMAIL PROTECTED]
> Arsip, FAQ, dan info milis di http://linux.or.id/milis
> Tidak bisa posting? Baca:
> http://linux.or.id/problemmilis
> http://linux.or.id/tatatertibmilis
> 
> 



salam

coba brctl addif nya diganti

 brctl addif br0 eth0 
 brctl addif br0 eth1

namanya juga jembatan (bridge) kok addif nya cuma ke eth0 aja ke eth1
nya juga donk :D
trus klo di brctl show kluarnya gini :


[EMAIL PROTECTED] root]# brctl show
bridge name     bridge id               STP enabled     interfaces
br0             8000.000629c90688       no              eth0
                                                                       eth1

CMIWW

salam
andhye

--
Unsubscribe: kirim email kosong ke [EMAIL PROTECTED]
Arsip, FAQ, dan info milis di http://linux.or.id/milis
Tidak bisa posting? Baca:
http://linux.or.id/problemmilis
http://linux.or.id/tatatertibmilis

Kirim email ke