OK I think I know what happened. First a question... how will the ad hoc networks look on the XO-1? They were still targets on these. Maybe I grabbed the wrong usb stick and put 10.1.2 on them again... but I don't think so.
I didn't see any parenthesis... just that the 2 XO-1s could see each other fine, but they couldn't see the 1.5s, even with sharing on. I started the Chat on a 1.5. Maybe it has to start on a 1.0? Caryl > Date: Sun, 6 Feb 2011 12:52:01 -0500 > Subject: Re: [Testing] [support-gang] Lost Communication in 10.1.3? > From: [email protected] > To: [email protected] > CC: [email protected]; [email protected]; > [email protected]; [email protected]; [email protected] > > Caryl, > > Once you connect to one of the ad-hoc networks, you will see the > familiar parentheses surrounding it. Then, in the Neighborhood View on > the the XOs, this network should appear as a wireless device. > > I would start troubleshooting by going o Settings and turning the > radio off and then on again. > > Good luck. > > Gerald > > On Sunday, February 6, 2011, Caryl Bigenho <[email protected]> wrote: > > > > > > > > > > > > Hi Gerald, > > > > That was the first thing I tried and it didn't work for me. I'll try it > > again when I get back from TX. How did you connect the 1.0 to the network? > > They are still showing as access points rather than the Mayan numerals on > > the 1.0s. Maybe I need to do the install again. > > > > Caryl > > > >> Date: Sun, 6 Feb 2011 11:39:38 -0500 > >> From: [email protected] > >> To: [email protected] > >> CC: [email protected]; [email protected]; > >> [email protected] > >> Subject: Re: [Testing] [support-gang] Lost Communication in 10.1.3? > >> > >> Caryl, > >> > >> I have been able to make this work. Here's what I did: > >> 1. Create an ad-hoc network on one of the 1.5s. > >> 2. Connect to it on the 1.0s. > >> 3. Open Chat and make public. > >> > >> Hope this helps. > >> Gerald > >> > >> On Sunday, February 6, 2011, Caryl Bigenho <[email protected]> wrote: > >> > > >> >tee's what I > >> > > >> > > >> >. > >> > >> H > >> > Hi... > >> > > >> > Prepping some XOs for our booth at SCaLE 9X Feb 26-27. When I first > >> > started charging and testing I was running 10.1.2. I tried Chat and > >> > found that the XO-1s could easily chat with the XO-1.5s. > >> > > >> > Then I updated all of them to 10.1.3, and this ability seems to have > >> > been lost. While the XO-1.5s connected right away to the ad hoc > >> > network, the XO-1s were totally left out. They can only see each other. > >> > > >> > Is this an intentional change? Is there a way for both models to > >> > communicate among themselves in 10.1.3? > >> > > >> > Caryl > >> > > >> _______________________________________________ > >> Testing mailing list > >> [email protected] > >> http://lists.laptop.org/listinfo/testing > > > >
_______________________________________________ Testing mailing list [email protected] http://lists.laptop.org/listinfo/testing
