Hello Tom, > Sounds good. Given that you still have many ns of > jitter in the 1PPS output you might want to consider > dividing your OCXO down to 1PPS and using that for > your master 1PPS user output; you can reduce the > output jitter 1000x that way. This is what HP did.
Yes, we do this, the 1PPS can be OCXO generated and adjusted to +-10ms of UTC with 16.6ns resolution via the keypad (or RS-232). We could make it adjustable to +-500ms with a small software change, but thought +-10ms range is probably enough. Does anyone here see a need to make the 1PPS output fully user adjustable to +-500ms of UTC? > The longer > you average the less this is a problem; 10 or 30 > minutes makes it a non-issue. But with much > shorter averaging times you can see how it might > cause trouble. Our unit is completely configurable via the LCD and keypad, you can set any loop parameters such as loop time constant, Proportional gain, Integral gain, Tempco compensation, Oscillator drift/aging etc via keypad commands. Setting averaging times of 10, 30min, or even hours is easy. Thus the user can decide what is more important: frequency stability or phase accuracy to UTC, and adjust the loop parameters accordingly. > The 8-bit 1 ns resolution part from Dallas/Maxim looked > pretty cheap to me. $5, I think. But wouldn't a 1ns delay line also require a TIA with at least <1ns resolution to make full use of the delay line resolution? > Note the 58503 and Z3801A receivers (now ten years > old) have 100 ps resolution. But I'm guessing your > 3.33 ns detector is cheaper than HP's! Very true, ours is cheaper and simpler (more reliable?). We retail the unit at $750 new in small quantities, versus HP's units which sell used for sometimes over $3K, see for example: _http://cgi.ebay.com/HP-AGILENT-58503A-GPS-Time-Frequency-Reference_W0QQitemZ7 631531606QQihZ017QQcategoryZ25399QQssPageNameZWD1VQQrdZ1QQcmdZViewItem_ (http://cgi.ebay.com/HP-AGILENT-58503A-GPS-Time-Frequency-Reference_W0QQitemZ7631531 606QQihZ017QQcategoryZ25399QQssPageNameZWD1VQQrdZ1QQcmdZViewItem) At the same time our OCXO and GPS receiver is much better than the one used on the 58503A, so our ADEV and Phase noise is significantly lower (ADEV is up to 8x better 100s to 1000s, phase noise is >10dB lower) than the 58503B for example. Some other improvements are: * our power consumption is 4.5W at 12V, the 58503B is <35W at 110V. * We have a 12 channel GPS, the 58503B is an 8 channel GPS * Harmonic distortion for us is: <<45dBc, for 58503B its <25dBc * Spurs ("non harmonic distortion") for us: <<100dBc, for the 58503B its <80dBc But I don't want to brag :) bye, Said _______________________________________________ time-nuts mailing list [email protected] https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
