); SAEximRunCond expanded to false Errors-To: [EMAIL PROTECTED] In a message dated 17/07/2007 23:09:36 GMT Daylight Time, [EMAIL PROTECTED] writes:
You should be able to restart the VP with the @@Cg command in the "Additional Message Window" in WinOncore12. The total command string is: @@Cg01<enter>. Note that with the VP this must be done after every receiver default or SelfTest. ---------- You will also encounter trouble trying to run a lot of the more esoteric 8 channel messages that the VP supported. WinOncore12 has no idea about what to do with these. Once again, Rick's software will come to the rescue. Best regards, Randy Warner Senior Applications Engineer Geodetics, Inc. --------------------------- Thanks Randy That saved the day. It was one of those things that seem silly when you know but a real pain when nothing wants to work. The unit did come with some earlier DOS software and a while ago I booted up the Dolch luggable, that I keep for the Z3801A and SatStat, and ran the DOS GPS90 software but that was doing the same thing. My problem??? The VP comand set document doesn't mention, or not that I can see anyway, the need for that leading zero, so I was using @@Cg1.....and it don't like that:-) Considering the antenna is only propped up on a ground floor window sill for now, and signal levels are on the low side, all is looking good, with a 10 degree mask angle it's seeing 10 or 11 satellites and so far tracking 3. It turns out to be an early 8 channel, a B3 model, but as long as it has the 1PPS output, that should be ok for what I need. Thanks too for the other information, I'll look out for a copy of TAC32 and try that later. regards and thanks again Nigel GM8PZR _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.