Try measuring a known length of the resistance wire, say 6 inches and then double. . .
Randy Hi Next step would be to figure out what a reasonable ohms / foot number is. Bob On Mar 21, 2010, at 12:41 AM, Chuck Harris wrote: > HP just wound two parallel wires around the cylinder. They did not > twist. The wires at the entrance end of the solenoid went to the > electronics, the wires at the exit end of the solenoid were shorted > together... I think they used a crimp for the short. > > -Chuck Harris > > J. L. Trantham wrote: >> Do you make a 'twisted pair' and then wind that or just wind two parallel >> wires around the cylinder? >> Joe > > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
