You may want to check out the 10MHz locked 1GHz clock I did
(using ADF4107 and a 1GHz Crystek CVCO)
http://www.qslnet.de/member/on4iy/1gclock/xlock-1g.html
and associated DDS to generate oddbal frequencies.
http://www.qslnet.de/member/on4iy/9912.html
Includes some PN measurements.
Xtof.
On 21/12/10 19:18, Mike Feher wrote:
Interesting. When I used to use and build DDSs back in the early 70's, we
typically used 2.56 times the maximum required frequency for a clock, to get
above Nyquist and allow adequate filtering stop-band rejection. At the time
we could not go much higher due to limitations in device speeds, especially
the D/A. Today you can easily use a much higher clock frequency which would
simplify filtering and reduce gain variations. At 70 MHz clock you are only
at 2.333 Nyquist. Even at 2.56 by the time you get to your desired goal of
30 MHz, you will have what looks just about like a square wave. So,
filtering will be a must, and, after filtering, you will find that your
amplitude output will greatly decrease with frequency. The other question is
phase noise objectives. If that is not a real concern, then as suggested,
maybe a simple locked VCO would be the way to go. 73 - Mike
Mike B. Feher, EOZ Inc.
89 Arnold Blvd.
Howell, NJ, 07731
732-886-5960 office
908-902-3831 cell
-----Original Message-----
From: time-nuts-boun...@febo.com [mailto:time-nuts-boun...@febo.com] On
Behalf Of Stephen Farthing
Sent: Tuesday, December 21, 2010 12:57 PM
To: Richard (Rick) Karlquist; time-nuts@febo.com
Subject: Re: [time-nuts] what is the best way to multiply a 10 Mhz signal?
Hi Rich....
Thanks for the reply....I have an AD9834 DDS chip I want to use for a
Frequency generator with an accuracy of 1 Hz from 0-30 Mhz. . This part can
be clocked at 75 Mhz - but unlike other DDS chips seems to have no internal
clock multipliers. So it seems to me if I can some how generate a 70 Mhz
clock signal from my rubidium standard I can solve the problem.
73s Steve
On 21 December 2010 17:36, Richard (Rick) Karlquist
<rich...@karlquist.com>wrote:
I used to be in the synthesizer business (Zeta Labs)
in a previous life. I learned to ask the customers:
what you are trying to accomplish as the end goal,
before tackling a messy problem like multiplying by
7. Maybe you don't need to multiply by 7, but we
can't tell from your question.
Rick Karlquist N6RK
On 12/21/2010 8:35 AM, Stephen Farthing wrote:
Hi everyone,
I want to multiply the output from my Efratom 101 (10Mhz) to clock a DDS
at
70 Mhz. Has anyone tried this?
Regards,
Steve G0XAR
Disclaimer: http://www.kuleuven.be/cwis/email_disclaimer.htm
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
