Folks I have been using your TimeLab for a while now. Here is what I do. The 10 MHz ref go into start and the dut 10 MHz goes into stop, both terminated in 50 ohms. I use the I PPS out of the 3801 to Arm the 5370b, so I assume the sample rate to TL is 1 PPS. I am set to "use in coming sample rate"
What I would like to know is .. Can I use TL to make my phase corrections to the DUT before commencing a trace? at 10 samples per sec I use the" phase original" which is moving fairly fast to try to obtain a flat line across the screen. Is this a reasonable way to do this? Is there another way within TL? Otherwise I have to take the system apart and run both sources thru the Spectracom Dividers to 5 MHz min. Adjust the phase meter (it only accepts up to 5 MHz) and put things back together. I built a divider network from .1% resistors so that that I now only need 200 ohms (OF THE 5 k POT) external to the oscillator to set the EFC. All the resistors are in contact with the Osc. housing which is buried in center of a 6" x 6"x 6" cube of insulation board. I have about r20 to the outside world. The EFC voltage is 3.9101 volts +/- .0001volts Still I see some pretty big phase changes over the course of a few hours. Anyway I am rambling Is there a meter or phase scope in TL that I am missing? Paul A. Cianciolo W1VLF http://www.rescueelectronics.com/ Our business computer network is powered exclusively by solar and wind power. Converting Photons to Electrons for over 20 years _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.