On 05/27/2012 07:10 PM, Magnus Danielson wrote:
How far off? What Rb do you have?
Most Rb:s not having a EFC input should be possible to modify for EFC in
one way or another, since the C-field needs to be applied regardless.
I don't know how far off it is. It's an Efratom 102100-001, which
there's very little information about. Most of what I know is from a
time-nuts post from 2006 (!) -- the pictures from that thread can be
found here: http://nixie.ramdac.be/
It's likely that it could use a tune-up because mine could not get a
lock when I first powered it up. I did the smart thing and twiddled
every single trim pot (after marking the original positions, bah) hoping
to get the sweep frequency in the right place. It was only after I gave
up and walked away for a few minutes that it locked. Now it locks in
under 3 minutes every time but I'm sure the 10mhz output could use a trim.
The outputs available through the main connector are 10MHz out, vreg
voltage, active-low lock indicator, Rb lamp voltage, and "xtal monitor"
which sweeps over a large range while it's looking for a lock. That
sounds nice, but even if it were pullable it would probably interfere
with the ability to lock to Rb. There are several internal headers but I
can't find any documentation on this particular model so their function
is a mystery to me.
Probably the intelligent thing to do would be to look for a good
pullable OCXO rather than designing around what I have. Wouldn't be much
fun, of course.
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.