Hi, I don't know this model from Austron, but you could try asking fellow Time Nuts if anyone has a manual for the 5000 which should include the full calibration procedure.
I know on the Austron 2000C the calibration procedure was quite a long to set it up correctly. I'm sure that the 5000 will be similar. Rob -----Original Message----- From: time-nuts-boun...@febo.com [mailto:time-nuts-boun...@febo.com] On Behalf Of mehdi Sent: 13 April 2013 13:08 To: time-nuts@febo.com Subject: Re: [time-nuts] Questions about Austron 5000 Loran C receiver > >hi dears i'm newer here. i have some questions about loran-c receiver.can you help me? i want to know how can i find third zero crossing in loran-c receiver? i find third zero cross by peterson 's method from this paper: Analysis of Noise and Cycle Selection in a Loran Receiver but due to Gausian noise,when i find third zero cross,it is not correct and it is before or after correct third zero cross.i want to know how can i track and correct third zero cross?(in other words what is acquisition in loran-c receivers and how can i do?) have you any matlab code or papers or thesis for this problems? pleassssssssssssse help me? :( thanks a lot > > _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.