Its a master timing rcvr from the simple research I have done. Must be fallout from the US LORAN C shut down. Anyhow The whole signal spec is here. http://www.navcen.uscg.gov/?pageName=loranSignalSpec Its a 8 MB zip I have done the 2000 procedure and it is complicated to say the least. Given the vintage of the 5000 it might be the same. But that was quite a while ago. Are you in the US? Regards Paul
On Sat, Apr 13, 2013 at 9:21 AM, Rob Kimberley <[email protected]>wrote: > Hi, > > I don't know this model from Austron, but you could try asking fellow Time > Nuts if anyone has a manual for the 5000 which should include the full > calibration procedure. > > I know on the Austron 2000C the calibration procedure was quite a long to > set it up correctly. I'm sure that the 5000 will be similar. > > Rob > > -----Original Message----- > From: [email protected] [mailto:[email protected]] On > Behalf Of mehdi > Sent: 13 April 2013 13:08 > To: [email protected] > Subject: Re: [time-nuts] Questions about Austron 5000 Loran C receiver > > > > >hi dears > i'm newer here. > i have some questions about loran-c receiver.can you help me? > i want to know how can i find third zero crossing in loran-c receiver? > i find third zero cross by peterson 's method from this paper: > Analysis of Noise and Cycle Selection in a Loran Receiver but due to > Gausian > noise,when i find third zero cross,it is not correct and it is before or > after correct third zero cross.i want to know how can i track and correct > third zero cross?(in other words what is acquisition in loran-c receivers > and how can i do?) have you any matlab code or papers or thesis for this > problems? > pleassssssssssssse help me? > :( > thanks a lot > > > > > > > > > > _______________________________________________ > time-nuts mailing list -- [email protected] To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
