a) Hit s then s again in LH. (survey) b) something else caused red light (bad osc?)
Adjust unit to correct UTC and co-ords may speed up. Where is the screen shot? --marki -----Original Message----- From: time-nuts-boun...@febo.com [mailto:time-nuts-boun...@febo.com] On Behalf Of Bob Camp Sent: Sunday, 8 September 2013 3:44 AM To: Discussion of precise time and frequency measurement Subject: Re: [time-nuts] New NTBW50AA Hi If it's trying to get a position *and* it goes below 4 sats due to antenna location, it will go to the red light mode. Once it's got a position it will hold in there with one sat. The modern nav GPS's are much more sensitive than the older GPSDO's, so you will need a better antenna location for them than for a new hand held. Bob On Sep 7, 2013, at 1:38 PM, quartz55 <quart...@hughes.net> wrote: > OK, I got the thing started up, the com port seems to work with LH. Of > course it says bad position. I've got a screen shot of the startup, after > about 15 minutes the green LED went on, indicating lock, but after about a > half hour, it went out and the red light went on indicating a fault according > to the book I have. I turned it off after doing a screen shot. I'll post > them later. > > I guess I need to figure out how to do a reset? > > According to the book, it should acquire the new position auto within 1 hour, > but not sure about that. I got a good stiff 30VDC supply feeding it and the > ripple is well under 100mV at the input to the connector. > > I found out don't stop the unit without exiting LH or it locks up the > computer. > > The Nuvi GPS gizmo I have gets the signals inside my shack, so I guess it may > be good outside in the clear above the roof. However, it may be hard to get > the antenna out from under the trees. > > I'm going to Paris (VA) to see Sylvie and have a martini. I'll be back in a > few hours. > > Dave > N3DT > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.