Hi The biggest issue is sawtooth correction. To take care of the sawtooth issues you need to sync up the correction data with the signal into the GPSDO. That's a lot easier when both come out once a second than when one is continuous and the other is still only once a second.
Bob On Sep 20, 2013, at 2:27 AM, Anthony Stirk <upu...@gmail.com> wrote: > Just as a note you can reconfigure the time pulse output any of the Ublox > modules (doesn't have to be the timing module) via commands to give out a > pulse up to : > > 7 Series :0.25 Hz … 10 MHz > NEO-6G/Q/M/P/V : 0.25 Hz to 1 kHz > NEO-6T :0.25 Hz to 10 MHz > > Don't know if this helps anyone. > > Cheers, > > Anthony > > > > > On Fri, Sep 20, 2013 at 3:24 AM, Bill Reed <br...@otelco.net> wrote: > >> Hi Merv, >> >> Thanks. I will try one. >> >> This is a great group! >> >> Bill >> >> >> -----Original Message----- From: Merv Thomas >> Sent: Thursday, September 19, 2013 9:01 PM >> To: time-nuts@febo.com >> >> Subject: Re: [time-nuts] GPS with 10KHz output >> >> Hi Bill, >> >> I have a number of these modules purchased from the particular eBay source >> you gave a link for. They work well but I never found a way to keep their >> data output as NMEA as they seem to revert to Binary on power down. >> However >> if it is just the 10KHz output you want from them or their Binary data >> stream they should be fine in my humble opinion. I have a small batch file >> that commands them into NMEA once powered up but nothing to save this >> setting. >> >> Merv VK6BMT >> >> ______________________________**_________________ >> time-nuts mailing list -- time-nuts@febo.com >> To unsubscribe, go to https://www.febo.com/cgi-bin/** >> mailman/listinfo/time-nuts<https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts> >> and follow the instructions there. >> ______________________________**_________________ >> time-nuts mailing list -- time-nuts@febo.com >> To unsubscribe, go to https://www.febo.com/cgi-bin/** >> mailman/listinfo/time-nuts<https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts> >> and follow the instructions there. >> > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.