I have a wave analyzer which for those who may be unfamiliar with such an
instrument is a super het receiver that tunes from 0 to 50 kHz. Mine has
enough extra range on the high end to hit 60 kHz. I can connect a 40 foot
wire antenna in my attic to its input and receive WWVB here in Kentucky. I
can see the variations on the meter or look at the frequency restored output
on a scope.
Regards.
Max. K 4 O DS.
Email: [email protected]
Transistor site http://www.funwithtransistors.net
Vacuum tube site: http://www.funwithtubes.net
Woodworking site
http://www.angelfire.com/electronic/funwithtubes/Woodworking/wwindex.html
Music site: http://www.maxsmusicplace.com
To subscribe to the fun with transistors group send an email to.
[email protected]
To subscribe to the fun with tubes group send an email to,
[email protected]
To subscribe to the fun with wood group send a blank email to
[email protected]
----- Original Message -----
From: "John Marvin" <[email protected]>
To: <[email protected]>
Sent: Thursday, February 20, 2014 11:08 PM
Subject: Re: [time-nuts] New WWVB modulation format receivers (NOT)
I have an OpenHPSDR Hermes and it has no problem receiving WWVB; however,
since I live in Fort Collins - Colorado, part of the success might just be
the strong signal. I wonder if I could just stick a piece of wire into one
of the channel inputs of a 192Khz sample rate audio interface (especially
if it had a good low noise mic preamp) and decode WWVB from baseband audio!
John
AC0ZG
On 2/20/2014 9:55 PM, wb6bnq wrote:
Hi Zim,
With but a very few exceptions most broadband Amateur radfio trancievers
do not do well below 500 KHz even though many allow for tuning below 500
KHz.
Bill....WB6BNQ
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
---
This email is free from viruses and malware because avast! Antivirus protection
is active.
http://www.avast.com
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
