Hi Paul, No, it's the right configuration. The part number is as you say and it says SSR-6tru on a paper label. I'm certain it's something on my end, but I just don't see it. I think I'm going to go the mini-clips route, assuming a USB adapter will power the board. I'll have to look at the specs to see current draw.
Bob ________________________________ From: Paul <tic-...@bodosom.net> To: Discussion of precise time and frequency measurement <time-nuts@febo.com> Sent: Wednesday, July 16, 2014 2:33 PM Subject: Re: [time-nuts] Synergy-GPS SSR-6tru problems On Wed, Jul 16, 2014 at 2:54 PM, Bob Stewart <b...@evoria.net> wrote: > I fooled around with PUBX 41, and can't get the board to respond. I had some problems but that's because they sent the wrong configuration (a 16062133G). What's the part number? Assuming it hasn't changed a TRu is 16062152G. > I don't have the ability to deal with those .05" spaced pins on the GPS > board's connector, or to supply the 3V power. I was able to compress and heat shrink some .1 connectors on a .05 connector although I didn't try it on the SSR-6T. -- Paul _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
