Dave,
I, too, hate piles of dumb little boxes. So when the Z3801 appeared I went
on line, bought some sheet aluminum of appropriate thickness, cut a "panel
sized" piece, drilled a few holes with an appropriate twist drill to allow
the start of a hacksaw and then finished the clearance hole for the 3801
with a file. I supported the 3801 with some aluminum extrusion angle stock
and then painted the whole she-bang with paint to match my stuff. And lo,
no dumb little box, and it fits a standard 19 inch rack perfectly. If you
send me an email address I will send a photo.
Lee
----- Original Message -----
From: "Dave M" <dgmin...@mediacombb.net>
To: "FEBO Time Nuts" <time-nuts@febo.com>
Sent: Wednesday, October 22, 2014 2:44 PM
Subject: [time-nuts] Z38xx rack mounts
I have a couple questions regarding the Z38xx type units. I have a Z3801A,
and a couple other modules that don't need a full 19" rack space. The
Z38xx
units are 11" wide (10-9/16" mounting centers) , and obviously are not
suitable for a standard 19" rack cabinet.
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
