Nigel,
These are standard HP 1/2 rack units. The rubber bezel around the
front and back peel off. HP (Agilent, now Keysight) makes a Link Lock
Kit
<http://www.ebay.com/itm/HP-Agilent-Lock-Link-Kit-5061-5458-/291271152251?pt=LH_DefaultDomain_0&hash=item43d11d127b>
to connect the units. The finger piece mount in the slots in the side of
the front bezel and lock together. The lock pieces strap the rear square
frame posts together. Add the 2U (each 'U' is 1-3/4") rack mount
flanges and you're good to go.
Mike
On 10/22/2014 4:26 PM, GandalfG8--- via time-nuts wrote:
Hi Dave
Many thanks for the MTI260 data, that's very useful and much appreciated.
As regards the the Z38xx modules, my Z3801As actually measure 10 9/16
between the front panel edges but obviously still too much to fit two like that
into a standard 19 inch rack.
I've considered two options on this, one is to keep the existing front
panel and just cut it down closer to the case itself and the other, prompted by
having one arrive several years ago with a bent front anyway, is just to
remove the existing front panels entirely and make up another panel to
accommodate two units side by side.
The actual cases themselves are 8 inches wide so two should sit side by
side quite nicely in a 19inch rack.
Regards
Nigel
GM8PZR
In a message dated 22/10/2014 21:44:42 GMT Daylight Time,
dgmin...@mediacombb.net writes:
I have a couple questions regarding the Z38xx type units. I have a
Z3801A,
and a couple other modules that don't need a full 19" rack space. The
Z38xx
units are 11" wide (10-9/16" mounting centers) , and obviously are not
suitable for a standard 19" rack cabinet.
Looking in the Z3801A manual, I see that the rack trays that these units
are
mounted in are 28.5" wide, with a dual mounting shelf so that two GPS
units
can be mounted side-by-side. Were the racks for these units custom built
by
Motorola and/or Symmetricom? Where in the civilized world might these
cabinets and mounting shelves be found and purchased (preferably surplus)?
I've searched Google until my eyes are crossed, but nothing shows up.
Maybe
I'm not using the right search terms? Don't know.
I guess I could destroy an old rack cabinet and fabricate something that
would fit the equipment, but I'd prefer to buy one (assuming that it
doesn't
approximate the cost of a new SUV).
Cheers,
Dave M
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.