U-Center vers 8.12
http://www.u-blox.com/en/evaluation-tools-a-software/u-center/u-center.html
Mike
---
73,
Mike, N1JEZ
"A closed mouth gathers no feet"
On 2014-11-21 18:54, Jim Sanford wrote:
what is the "ublox application"????
Thanks,
Jim
wb4...@amsat.org
On 11/20/2014 6:17 PM, S. Jackson via time-nuts wrote:
Paul,
if you set the serial switch on the LTE-Lite over to the NMEA side
then the
uBlox application will give you all sorts of bar graphs for signal
strengths, position, time, etc as it decodes all the NMEA messages.
Alex,
the TSC5125A user manual contains a description of the theory in its
Appendix B. Its probably available on the Microsemi website as I don't
think its
confidential.
Also, I think John's TimePod user manual probably has a description
of it.
Otherwise I remember Sam Stein (who is behind the TSC units) had some
PTTI
or similar presentations discussing the technology, but I don't know
where
those could be downloaded.
Bye,
Said
In a message dated 11/20/2014 14:34:32 Pacific Standard Time,
a...@pcscons.com writes:
Hi Said,
do you have any information about how that "TimePod 5330A works" any
principal description?
73
KJ6UHN
Alex
On 11/20/2014 2:08 PM, S. Jackson via time-nuts wrote:
Hello Mike,
attached is a 10MHz DIP-14 TCXO Phase Noise plot from a random
LTE-Lite
unit.
I had sent out a 20MHz typical phase noise plot some weeks ago,
and
comparing the two they are almost perfectly 6dB apart as would be
expected from
the 20log(n/m) relationship. There are variations from unit to unit
of
course, but it does not seem like one version of the board or the
other
has
advantages in terms of phase noise.
I had also sent out a superimposed plot of the 20MHz and the
divide-by-2
10MHz output of the same board at that time, and again the
relationship
was
almost perfectly 6dB lower at 10MHz versus 20MHz.
While phase noise follows theory, it does seem that the DIP14
metal
shield
has a beneficial effect on the ADEV stability though. The plots we
are
getting are pretty darn good, and I want to test more boards
before I
post any
ADEV, because its quite a bit better than our specification and I
want
to
make sure its real.
The 10MHz DIP-14 boards do not have an isolating buffer like the
20MHz
boards do, on these the TCXO drives the output directly, so one must
be
careful
to set the equipment to 1M Ohms input impedance or use a buffer
externally, which is what we did to measure the attached PN plot.
Bye,
Said
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
---
This email is free from viruses and malware because avast! Antivirus
protection is active.
http://www.avast.com
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
